Motor BoatsRunaboutsEx Pilot Boat - Twin Engine - Needs work - Project BoatModel n/a
Ex Pilot Boat - Project Boat - Needs Repair
Original specification was as below. The Pilot Boat is now need in need of repair. Please note this is for sale as is where is - price reflects condition. Buyer must have transport avaialble to take away promptly once sale concluded. She has been stored out the water many years. Was brought to current place of storage on own steam / by water. Could be line boat , small workboat or similar once works completed or used as fishing vessel - subject to any necessary certification etc.
DFT: 1.2m, Air DFT: 5.80m including aerials.
Displacement: 7.3 t.
Engines: 2 x Ford Mermaid 2705E with 380cu inch (6.22 ltr) normally aspirated
6 cylinder diesels. Heat exchanger sea water to fresh water cooling. 120 hp @ 2450 rpm.
Exhaust System: Wet type, water injection at engine manifold.
Transmission: Reversing Gear boxes Make Borg Warner
Propellers: Props 17 x 12 LH bronze
Turbine 1 1/2” bore
Velvet Drive Type 1018002 Ratio 1:1
Prop Shafts: Shafts 11/2” Total 2606mm ( 2530 end to end of taper plus 2 x 38mm thread)
Fuel capacity – c300 litres.
Any questions please ask. Note the last photo shows what she looked like afloat - after this picture was taken she was lifted out and stored.
...Read full description
ManufacturerEx Pilot Boat - Twin Engine - Needs work - Project Boat
Mooring CountryUnited Kingdom
Length9 m/30 ft
Conditionin need of repair
No. of engines2